Raven Cruizer II Manuel de l'opérateur télécharger pdf (Page 52)

Chapter 8

46 SmartBoom and SmartRow Installation and Operation Manual

Individual Fore/Aft Offset Screen

To get to the Sctn 1 F/A Offset screen, press from the last Sctn L/R Offset screen.

Note: These screens will only appear if “No” is selected on the AutoLocate Sctns screen.

The Sctn 1 F/A Offset screen displays the distance section number 1 is located in front of (fore) or

behind (aft) of the center of the GPS Antenna.

Press key to edit the L/R Sctn Offset. The number will begin blinking to indicate you are in edit

mode. Use the or key to increase or decrease the value representing the Fore/Aft offset of

the section. Use the key to move between digits and Fore/Aft selection. Press the key again

to finish editing.

Note: Continue pressing to wrap the curser back around to the most significant digit.

Press to edit the Individual F/A Offset for sections 2-10. The actual number of Sctn Fore/Aft Offset

screens will depend upon the number of sections programmed on the # Of sctn screen.

Sctn 1 Fore/Aft

50” Aft

RAVEN

HOME

INDUSTRIES

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 97 98

Pas de commentaire

Raven Cruizer II Manuel de l'opérateur Page 52